![]() ![]() Which in my case is an issue with my ecu or cable not program. I can now access groups past 025 and other functions previously could not, however on some of these for me I can get a reading but particular signal is erroneous. Note - not all groups will or should have a response reading, check with rosstech or online for valid group numbers If you can get a reading with 'ANY GROUP' after 025 (which the limit for the free version) the registration worked. ![]() This than can be confirmed by going back to cont mod >engine > measure blocks. Go to select control module > engine controller > check fault codes & ignoring what ever codes you may have gotten now go back to about button - status now shows full reg. At this stage program equal to freeware, this can be checked by clicking the about button, status software needs to be tested on car. To help clarify - Installed program, set/test cable/port in program. ![]() However this seems more likely to do with either the cable I'm using or some previous modifications I have had done to the car itself (things others may need to consider). Tested and confirmed application works, well at least part works for me. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |